How do I hold a glue-up square while it sets?
Share
Measure corner to corner both ways, nudge until the two match, then clamp across the joint and check again.
To hold a glue-up square while it sets, clamp it up and measure the two diagonals from corner to corner. If both measure the same, it's square. If they don't, the longer one is the one to squeeze, and a parallel clamp across the joint will hold it there while the glue goes off.
How do I know it's actually square?
Run a tape from one inside corner to the opposite inside corner, then do the other pair, and use the same spot on each corner both times. If one reads 2mm longer, put a clamp along that longer diagonal and tighten it a little at a time, measuring again as you go. It moves less than you'd think, so go gently.
measure both diagonals, they match
Then check each corner with a square, because a frame can have matching diagonals and still have a corner that's off. Hold the stock of the square hard against one face and look for light under the blade. A combination square does the job, and the Kincrome one has an etched stainless steel blade and a die cast aluminium body.
Which clamp should I use?
It depends on the size of the job. Here's what I can tell you about each from the listing and the maker.
| Clamp | What we know |
|---|---|
| Lockjaw Aluminium Parallel Clamp 600mm | 600mm, aluminium, parallel clamp. Check the jaw depth and clamping force on the packaging, or measure the jaw depth off the clamp itself, before you rely on it for your job. |
| Lockjaw One Hand Bar Clamp 300mm, Plastic, L112 | 300mm, nylon composite body, reinforced carbon steel bar, changeable V-grooved or flat pads, up to 200kg clamping force |
| Lockjaw Ratchet Clamp 63mm | 63mm jaw opening, V-grooved swivelling pads, nylon composite body |
For a cabinet or a good-sized frame, I'd reach for the 600mm one. For smaller boxes and picture frames, the shorter ones are easier to handle.
What if it keeps pulling out of square?
Check the bench first, because a glue-up on a bench that isn't flat will twist, and no amount of diagonal measuring fixes that. Lay a straight edge across it, and if it's twisted, pack it out until the frame sits flat.
The other common cause is clamping too hard on one side, which bows the joint. Do a dry run before any glue goes on so you know where each clamp sits, and read your glue's tin for how long you've got to get it all square.
If you're sure which clamp you need, it's on the site. If you're not, send us a message with the size of what you're gluing and we'll talk you through it, or bring the job in and we'll have a look at it together.
Cheers,
Candeece





