How do I cut plasterboard for a power point?
Share
Cutting a neat power point hole in plasterboard with hardly any dust comes down to this: trace the mounting box on the wall, drill a small pilot hole inside the line, then cut slowly just inside the line with a plasterboard hand saw or a jigsaw on a low speed. Hold a vacuum nozzle against the wall as you go and most of the dust never hits the floor. Check behind the wall for cables before you cut, because that's the one mistake you can't undo.
If you'd rather use a jigsaw, this is the one I'd point you at. It's a bare tool, so you'll need a KATANA 18V battery and charger if you don't already have them.
It has variable speed, which is what you want here, because plasterboard crumbles when you rush it. The blade change needs no tools either, so swapping blades halfway through a job is quick.
How do I make sure I don't cut into a cable or a stud?
Turn the power off at the switchboard first, then drill a small pilot hole inside your traced line and have a look in with a torch. You're checking for cables, pipes and timber before you commit to the whole hole. A stud finder helps, and so does remembering that cables usually run straight up and down from existing power points and switches. Moving the position 50mm sideways is a lot cheaper than repairing a cable.
pilot hole, look, then cut
How do I get the hole the right size?
Hold the back of the box or the mounting bracket flat against the wall, check it with a level, and trace around it with a pencil. Then cut just inside your line, not on it. You can always shave a little more off with the saw, but you can't put plasterboard back, and a hole that's too big leaves the faceplate gaping.
Test the box in the hole every so often as you cut. It should push in snug without a fight.
How do I keep the dust down?
Have a second person (or just yourself with one hand free) hold a vacuum nozzle against the wall right below the cut. Run the saw slowly so the gypsum snaps off in chunks instead of turning to powder, and lay a drop sheet under the spot because the odd bit will still fall. If you're cutting into an old wall, leave the vacuum on for a minute after, since the cavity behind holds more dust than you'd think.
What if it's not the jigsaw I need?
For one hole, a plain hand plasterboard saw does it fine and makes less dust than a power tool, so don't feel you have to buy a jigsaw for this. It's slower, but it's totally fine, and it's also how you'd trim a hole that came out a touch tight.
One more thing worth saying. Cutting the hole is a DIY job, but connecting the power point itself has to be done by a licensed electrician. So cut the hole, leave the cable alone and call your sparky.
If you're sure the jigsaw's the right call, it's on the site. If you're not, ring us on (08) 8536 4333 or message with what you're cutting, and we'll talk you through it.
Cheers,
Candeece



