Which fluoro tube fits my light, like a T5 13W?
Share
Read what's printed on the old tube and buy the same one, because T5 and T8 tubes don't swap.
The tube that fits your light is the one that's already in it. So a light with a T5 13W in it needs a T5 13W, and a T8 58W light needs a T8 58W. Match the printing on the old tube and you'll get the right one.
The one I can put in your hand is a T8 58W, 1500mm long. If your old tube says that, this is it. If yours says T5 13W, it's a different tube and you shouldn't order this one.
How do I read my old tube?
Switch the power off at the wall and let the tube cool down. Twist it a quarter turn and it'll come out of the holders. The printing is usually along the glass near one end. You want these:
- The T number. That's the width of the tube. A T5 is thin, about 16mm, and a T8 is fatter, about 26mm.
- The watts. It'll say something like 13W or 58W.
- The length. Measure the whole tube with the metal pins on, because the printed length doesn't always match.
Put those side by side with whatever you're buying. If one of them is off, it's the wrong tube.
read the old tube, then buy
Why won't a T5 go in a T8 light?
Because the ends are different. The 58W tube I've linked has a G13 cap, which is the two-pin end on most T8 tubes, and a T5 has a smaller pin end again. The holders in your light are made for one or the other, so a thin tube won't just sit in a fat tube's fitting.
What do the numbers like 840 mean?
That's the colour of the light. The 840 on the 58W tube is a cool white at 4000K, which is a clean white that suits a shed or garage. If you're replacing a tube, it's worth matching the colour too, or one end of the shed will look a bit different to the other.
What if the right tube still flickers?
Then it's often the starter, which is the little cylinder you twist out of the fitting next to the tube. It's a cheap thing to try before you go buying a new light. The HPM one below is a universal starter for tubes from 4W to 65W and it comes as a twin pack.
Not every fitting has a starter. Some newer ones don't, so if you can't find one, it's totally fine to leave it and bring the tube in instead.
If you're sure of what's printed on your tube, the 58W is on the website. If you're not, bring the old tube in to the shop, give us a call, or message us what's printed on it and we'll work it out with you.
Cheers,
Candeece





