How do I stop rust on bare galvanised or steel outdoors?

How do I stop rust on bare galvanised or steel?

Stopping rust on bare galvanised or steel outdoors with a zinc-rich cold galvanising coat

Stopping rust on bare galvanised or steel outdoors, the plain way.

Clean the metal back to bare, dry and rust-free, then coat it with a zinc-rich cold galvanising paint. The zinc in the coat is what protects the steel, so the job is mostly about getting the surface right before you spray. For a weld, a cut end or a scratched patch, a 400g can does it.

Dy-Mark Zinc Guard Cold Galvanising Coating 400g, Matt Grey

Dy-Mark Zinc Guard Cold Galvanising Coating 400g, Matt Grey

See it in our online store

How do I know the metal is ready to coat?

Dy-Mark says the surface needs to be clean, dry, and free from rust, oil, grease, dirt and salt. If you can see orange or brown, it's not ready, so wire brush or sand it until you hit bright metal. New welds should be ground back to clean white metal, and new bare steel needs a good sand.

White chalky powder on old galvanising is the zinc itself wearing away. Brush that off too, and check what's underneath. If the steel is flaking through or has gone thin, a coat of paint won't bring it back, and the part needs replacing.

How do I spray it so it doesn't run?

Shake the can for at least 45 seconds after the ball starts rattling. Hold it upright 20 to 25cm from the metal and put on several light mist coats rather than one heavy one, because a heavy coat sags. Pick a day between 10 and 40 degrees with no wind, which means skipping the afternoon the dust is blowing across the paddock.

One can covers about 2m², so a fence line of cut ends and welds goes a long way, but a whole gate won't.

Which one do I need?

Product What it is Good to know
Dy-Mark Zinc Guard Cold Galvanising 400g, Matt Grey Aerosol, zinc-rich primer for bare metal, galvanised iron and wrought iron Matt finish, 400g aerosol
Anchor Shield Cold Galvanising 1 litre Tin of cold galvanising coating for rust and corrosion defence and galvanised touch-up Dangerous goods item, in-store pickup
Dy-Mark Zinc Guard Silver Bright 350g Aerosol anti-corrosive silver paint Can be used as a top coat over Zinc Guard Cold Galvanising

What if I've got a bigger job than a can covers?

The 1 litre tin is the bigger option if you've got more metal to cover. Read the label on the tin for how to apply it and how much area it covers before you start. It's an in-store item, so it's one to pick up from us.

ANCHOR SHIELD COLD GALVANISING 1 LITRE

ANCHOR SHIELD COLD GALVANISING 1 LITRE

See it in our online store

What if I want it to match the shiny galvanising?

Matt grey is fine for a weld that nobody looks at. If it's on show, Zinc Guard Silver Bright is made to match the bright finish of hot dip galvanising, and it can go over the Zinc Guard Cold Galvanising once that's on.

Dy-Mark Zinc Guard Silver Bright Anti-Corrosive Spray 350g

Dy-Mark Zinc Guard Silver Bright Anti-Corrosive Spray 350g

See it in our online store

All of these are dangerous goods, so they can't go in the post. The Dy-Mark cans are pickup from the shop in Strathalbyn or our local delivery. If you're not sure which one suits your job, send us a photo of the metal and we'll talk you through it, or bring a bit of the rusty part in and we'll have a look.

Cheers,
Candeece

Back to blog